Hi Community. How do I implement the non-periodic/periodic functionality from ACP10 in the CamTableSelect function with MappMotion/MpAxisCoupling? I’m using the camlist axis feature. I have a master axis running and I want the slave to run a defined cam at a specific master position a single time…

Hello, i am not sure if this parameter ever had an effect, i recogniced it more as a user Info, to know how the CAM was intended to use. A periodic CAM is a cam with same gradient at Start and End. If there is a different gradient, it has to be considered as non Periodic. The features of the CAM A…

I believe if you are trying to run a non-periodic cam with MpAxisCoupling, you would need set and reset the Cam command Signal appropriately. This will cause the block to do the configured, lead in, cam, and lead out configurations. If you look under timing diagrams, it even says if you reset the Ca…

MpAxisCoupling - Non Periodic Cam - #4 by system - Mechatronics & Motion

Topic		Replies	Views	Activity
Master period /Slave period of a cam must be an integer Mechatronics & Motion automation-studio	7	229	June 6, 2025
Issue with Automat coupling Mechatronics & Motion mapp-motion	1	155	August 29, 2025
Make periodic axis (0-360deg) for X67SM2436 Mechatronics & Motion motors , acp10 , stepper	9	158	March 14, 2026
Cam automat in mapp motion without the axis features Mechatronics & Motion mapp-motion	5	216	June 2, 2025
Error -1067317248 / -1067317239(The specified master can't be used for the coupling) Mechatronics & Motion mapp-motion	6	187	October 30, 2025