Hello, I have three Acopos P3 SafeMotion, two 8EI034HWSS0.0200-1 and one 8EI017HSS0.0600-1, and two works fine, but one (8EI034HWSS0.0200-1) has some problem, the LED SE is constantly on. I installed the latest version of the SafeMotion hardware module and AcoposP3, but it did not help. It has bee…

And Roman’s suggetion was to switch the drives and see if the issue stays on the same drive. But it looks like, just as said, that the drive is at fault. Contact your local B&R office and get it exchanged I guess

Hi Mihajlo, This looks like a holding brake error. [image] Have you double checked the wiring to ensure that the brake is wired correctly? If your other axes are functioning correctly, I recommend comparing the wiring between this axis and the others.

Hello @s4gia , I have a similar problem as you had. Did you solve it? On one Acopos P3 (8EI034HWSS0.0200-1) the LED SE is constantly on. It has been doing this since the first power up. I am using AS (4.12), Safedesigner (4.4.1), ACP10/ARNC0 5.29.1, mappSafety 5.24.1, AR P4.93, the main controller…

[image] Mihajlo_Tatovic: I have three Acopos P3 SafeMotion, two 8EI034HWSS0.0200-1 and one 8EI017HSS0.0600-1, and two work fine, but one (8EI034HWSS0.0200-1) has some problem Did you already try to exchange the two 8EI034HWSS0.0200-1 ? To see if the problem sticks to this specific hardware o…

@Mihajlo_Tatovic I have moved this question into this topic of yours since it’s the same issue asked twice Please keep it to one topic next time. @Zwi Fyi in case you are looking for this topic, this should ping you :slight_smile:

Hello @marcusbnr , I tried swapping drivers and again this driver is in the same error status. So I most suspect a software (some register or firmware collision) problem because the driver is new and has been behaving like this since the first time it was turned on. @michael_w Thank you for mergi…

I have two same Acopos P3 SafeMotion (one works and one fail), to check the wiring/cable I did the following: I switched each cable from the working driver to the faulty one, and from fault driver to wrking driver. The situation is the same, the faulty driver still gives the same error. This mean…

Acopos P3 SafeMotion Problem SE LED constantly on

Ask Questions Mechatronics & Motion

michael_w (Michael W) September 30, 2025, 3:34pm 8

If you changed the drives and the error went along WITH the drive, the drive itself has a fault. Unfortunately it’s not very clear from your phrasing.

Topic		Replies	Views
ACOPOS P3 Axis Lights Not Working Mechatronics & Motion acopos-p3	16	114	May 4, 2026
The axis lights are flashing green Mechatronics & Motion acopos-p3 , mapp-motion	16	163	May 8, 2026
How to Enable a SafeMOTION ACOPOSmulti drive? Mechatronics & Motion integrated-safety , acopos-multi	15	836	September 30, 2025
ACOPOS P3 axis error. Led green blinking Mechatronics & Motion acopos-p3 , mapp-cockpit	4	581	March 11, 2025
Error accopos Mechatronics & Motion acopos , automation-studio	4	1069	August 17, 2024

Acopos P3 SafeMotion Problem SE LED constantly on

Related topics