Hello everyone. The axis lights are blinking green. I checked the manual to see what’s wrong, but it doesn’t show any problems. All four of my axes are in the same condition: one HWS17 and one HWT4X5.

I had assigned trigger1 to quick stop and set trigger1 to low, but I was getting this error because trigger1 wasn’t appearing.

Can you tell us what the problem? Axis are not moving at all?, not moving as expected? etc… -Which leds are green ( I assume from ACOPOS P3? or Mullti?), which software are being used? ACP10 or mappmotion? -If axis are not moving when the command are sent, you may check the logger to see any entry…

Hi there, have you already looked inside the logger in Automation Studio? There you can normally find all relevant information about errors and co. Please also tell us more about your used AS version, with all mapp Modules, so troubleshooting will be easier! BR Julian

Hello, I’m using an Acopos P3. The driver enables, but I can’t power on the axis because the “ready to power on” message doesn’t appear. The axis lights are green but blinking. I’m using an ACP10. I can’t figure out why this is happening. I checked the logs but there doesn’t seem to be any problem.…

For the Acopos P3, the LED codes can be found here: Ax1/Ax2/Ax3 - LED status indicators So, it would seem these are the possible errors: The module is not ready for operation. Examples: No signal on one or both enable inputs DC bus voltage outside the tolerance range Overtemperature o…

Hello, is it a SafeMotion Drive? Whats the material and/or serial number? Lg Michael

I would expect a missing enable signal or missing 3 phase power supply. Check network command trace of the drive.

Hello, If ReadyToPowerOn is not TRUE you can just PowerOn and then you will see the Error Messages due to some missing preconditions. There was a Community Thread where one member had mentioned a way to trigger this errors without a power on command but i don’t remember, and could not find in sho…

If you write PARID 340 [CMD_ERR_STATE_INTO_FIFO] to 1 on the axis giving you trouble, it will give you all the reasons that keep it from going into ReadyToPowerOn state. Good luck!

The axis lights are flashing green

Ask Questions Mechatronics & Motion

eem.ferhat (dmr) February 26, 2026, 8:09am 7

Topic		Replies	Views
ACOPOS P3 Axis Lights Not Working Mechatronics & Motion acopos-p3	16	149	May 4, 2026
ACOPOS P3 axis error. Led green blinking Mechatronics & Motion acopos-p3 , mapp-cockpit	4	613	March 11, 2025
Acopos P3 SafeMotion Problem SE LED constantly on Mechatronics & Motion acopos-p3	8	221	October 1, 2025
AS6.3.4 mapp motion issue: axis configuration problem Mechatronics & Motion mapp-motion	14	218	December 18, 2025
Acopos Encoder error Mechatronics & Motion acopos	5	134	June 9, 2026

The axis lights are flashing green

Related topics