We have configured an X20CP0482 CPU with an X20BC0083 bus controller on an Ethernet POWERLINK network. The node is operational and cyclic communication is established. We want to use the Asynchronous Channel (ASnd) to send SDO and NMT-related ASnd commands to the X20BC0083. SDO-related ASnd servi…

Closed by moderator due to inactivity of author

Hi Nishit, The POWERLINK Bus Controller User’s Manual has some information on the X20BC0083’s object directory. If you can’t find the information you need there, I recommend reaching out to your local B&R support channel with these questions. The Community is best suited for more simple questions o…

Hello @marcusbnr We are using Automation Studio v6.1.1.14 with X20CP0482 (MN) and X20BC0083 (CN) over Ethernet POWERLINK. I had already referred this manual POWERLINK Bus Controller User’s Manual However, we would like clarification or support on the following points: Is there any supported met…

It is not clear, what you are trying to achieve. The SDO and NMT commands are sent by the Powerlink master = MN (Managing Node). The AsEpl library supports only EplSDORead() and EplSDOWrite() functions, which can read/write one SDO-object from a MN (CPU) or CN(BC) node. In the Powerlink Protocol E…

Hi @Nishit I see you made a new post with some related questions. [image] Wanted to observed traffic on UDP port 3819 and configured Asynchronous communication parameter Controls & Vision We successfully captured POWERLINK traffic using Wireshark. The traff…

ASnd command support for X20BC0083 over POWERLINK

Ask Questions B&R Software & Runtime

marcusbnr (Marcus Mangel) May 12, 2026, 12:15pm 5

Hi @Nishit I see you made a new post with some related questions.

Are you still looking for help with the topic in this post? Has the information provided by Corne helped you?

Topic		Replies	Views
How to configure Ethernet POWERLINK on X20CP0842 CPU with X20BC0083 in Automation Studio v6.1.1.14 Controls & Vision powerlink , automation-studio-6	5	113	April 30, 2026
Wanted to observed traffic on UDP port 3819 and configured Asynchronous communication parameter Controls & Vision powerlink	5	121	May 25, 2026
Power link configuration B&R Software & Runtime powerlink	25	430	January 27, 2026
Clarification Required on object directory / object parameter not visible Controls & Vision automation-studio , powerlink	4	83	May 7, 2026
Is it possible to send NMT commands in Powerlink? B&R Software & Runtime powerlink	7	124	February 26, 2026

ASnd command support for X20BC0083 over POWERLINK

Related topics