Hello B&R Community I am completely new to AS4 and B&R in general, but i have gotten my hands on a C70 Panel that i wanted to try programming something onto. I configured my hardware, which is the aforementioned C70 Panel, along with an X20 Row that includes 5xSM1446-1 modules and 5xZF0000 Module…

Hello Jaroslav, sorry for not replying any earlier. I have managed to solve the issue! i logged into my router and found the automatically assigned IP, and then connected to it. After that, i have set the IP in my project to match the Automatically assigned IP, and have added a rule in my Router to…

I forgot to mention, but i have also tried to ping other IPs in the hopes of getting access to the Panel, such as: 192.168.1.10 192.168.1.1 192.168.0.1 But none of them give me any response back on the controller.

Hello Emil, and welcome to the B&R world! To get connected, you’ll first need to know how the IP address was configured in Automation Studio. The settings in the project you transferred would have overwritten anything that was already there. To see this, go to your Physical View, right-click on the…

Hello Marcus This is what my Settings for ETH on the Panel looked like when i opened them now. It seems that it did get the IP from a DHCP Server. Do you know how i would then determine what the current ip Then would be? i should mention, that i am running this on my home internet for now. I will…

Hi @Emil_Andreasen , normally in your case I follow the guidelines described in this post: [image] Determining a PLC's IP Address using Wireshark How-To & Wikis Introduction There are many scenarios in which someone may want to connect to an Automation Runtim…

It’s very helpful that PLC is on your home network. The article Valerio linked is a good option. However, you can also access the administrator settings of your home router/modem and probably find it’s IP address there (if you’re familiar with how to do that). If you were in this spot and couldn’t …

Hi @Emil_Andreasen , what is the status of your issue, have you established connection?

4PPC70.0573-20B stuck in Boot mode: SERVICE after trying to transfer Program

Ask Questions B&R Software & Runtime

valerio.manenti (Valerio Manenti) March 10, 2026, 3:14am 5

Hi @Emil_Andreasen ,
normally in your case I follow the guidelines described in this post:

Thanks
Ciao
Valerio

1 Like

Topic		Replies	Views
-b&r-4ppc70.0702-20f008 boot mode: boot HMI & Visualization automation-runtime , t-c-panels	13	975	April 16, 2025
X20CP048 Download code Problem B&R Software & Runtime automation-studio , automation-runtime	12	330	November 10, 2025
B&R Power Panel 44PC70 BOOT Error HMI & Visualization t-c-panels	7	485	April 17, 2025
Transfer Eth configuration as DHCP server Controls & Vision automation-studio , plc	8	340	July 2, 2024
How to Connect to a PLC with an Unknown IP Address How-To & Wikis plc	5	3610	December 1, 2023

4PPC70.0573-20B stuck in Boot mode: SERVICE after trying to transfer Program

Related topics