Hello B&R Community members, I’m learning how to use a AcoposMicro 100D drive. I don’t have B&R motors to learn with, but I do have a 24V Beckhoff motor that I think could integrate with the AcoposMicro. I created a simple project to try to move the servomotor, but when I try to start it, Mapcockpi…

Hello, The Servo Loop Optimizer is a tool which is specificaly designed to analyse the Frequency Responce of the Motor Control Loop. It is used to set up the Filters of the Speed-Controller if needed. The tool is mainly focusing on optimizing the Controll Loop not to do initial commissioning. The…

Hi, PLCopen state “Invalid configuration” means that necessary parameters are missing in the configuration. In your case most likely the motor parameters. Here is how to set 3rd party motor parameters for ACOPOS drives. Add a “MotorSynchronous_any” component to the “System designer” or the “Phys…

Hello, did you follow this article mapp Axis - Getting started ? It might be a good idea to start with a simulated motor until the axis software boots up without errors and you are familiar with the mapp Axis software environment: [image] and then address the more sophisticated job with 3rd…

Thanks very aprecciated answers, I do your recommendations there is another part on AS, where I need to configure other things?, here is my current config. [image] [image]

Hello, please post a System Dump (Parameters + Data Files)

Hi @jesus_najera , can you update us on what the final solution was for you? :slight_smile:

Hello dear Jaroslav, As Christoph Hilchenbach rightly mentions, configuring third-party motors for the ACOPOSmicro is quite an interesting and difficult challenge for me. What I tried was a different approach to attempt to move my 24-volt Beckhoff AM3111 motor. I managed to make some progress, but …

Hello, i am a bit confused as there are pictures of mappCocpit (mappMotion) and Test-Window (Apc10); which system did you intend to use. As the last picture was Test-Window i will use Test-Window in my Post. Winding Cross Section This value is more for the Temperature-Modell not for motor moveme…

[image] michael.bertsch: Mode “Stepper” Hello Michael Bertsch, Thank you very much for your guidance. Regarding what you mentioned about the confusion, it is true that I did not clarify it, my apologies. Initially, I wanted to use mappcockpit because I saw some tutorials on YouTube about how…

Hi @jesus_najera , I think you got a lot of good advice here. Can you update us with the status of your issue or mark the reply that helped you the most? Thanks!

I just want to say thank you. Although I haven’t been able to freely carry out engine movements because I’m struggling with the custom configuration, I’m learning a lot. Thanks to the site administrators for allowing me to learn so much.

Beckhoff am 3111 0301 with acopos micro 100d

Ask Questions Mechatronics & Motion

Topic		Replies	Views
Running different brand servo motor with ACOPOS P3 Mechatronics & Motion acopos-p3	3	366	June 21, 2024
Running different brand servo motor with ACOPOS 1016 Mechatronics & Motion acopos , motors	17	559	December 13, 2024
B&r motion training module Mechatronics & Motion	13	180	February 11, 2026
X20cp1382 and acopos 1090 Mechatronics & Motion acopos , automation-studio , automation-runtime	31	2316	May 8, 2024
ACOPOS 8AC141.61-3 and 8v1090.00-2 how to run basic motor rotation test Mechatronics & Motion acopos , automation-studio	7	117	February 10, 2026

Beckhoff am 3111 0301 with acopos micro 100d

Related topics