Hi everyone! I´m traying to create a new project in which I´ve assigned in the online settings an IP (192.168.1.231) to TCPIP connection. Then I´ve connected to it. Afterwads, I have connected my PC and the Panel PC 3100 I have, via an ethernet cable to the ETH2 port of the panel. I have assigned …

Hi, by now I’m not completely sure what’s happening. 4808 is a online protocol status that means more or less “the communication driver is unable to reach the PLC configured for online connection”. Status 4808 can happen for many different reasons, e.g. “wrong online connection in Automation Stud…

Hello, good afternoon. First of all, I would like to thank you for your quick reply. In relation to the questions you asked me, yes, you are right! I´ve done the initial setup of the Automation Runtime. Regarding to the SMD is not being reachable, the error that is appearing in the browser is ERR…

Hi and good afternoon, too! Thanks for providing additional information. To be honest, I’m not sure if we can figure out the root cause without the help of your local support contact at B&R, the behavior sounds “special”. But: I know at least the IP address 192.168.137.1 at Automation Runtime as …

Hi, You can check details in Automation studio help, in establishing a connection to the target system section https://help.br-automation.com/#/en/4/programming%2Fonline%2Fonline.html Best regards!

Good afternoon: I´ve check the IP adress of the ETHinternal and I have exactly the same IP adress that you have in the photo you´ve shared. Finally, I have managed to open the SMD by reinstalling the B&R Hypervisor driver. Once I have done this I have built the project but it still does not give m…

Hi, if only ETH9 is shown in SDM, maybe both physical interfaces ETH1 and ETH2 are configured for use in the GPOS? In the Automation Studio project, you can check this by checking the Physical view: if a devices is configured for GPOS, it’s “grayed out” in the hardware tree and has a extension " …

Hi, No, I have only configured the physical interface ETH1 for use in the GPOS, the ETH2 is set as AR embedded. Thisone is the one which the IP adress is 192.168.1.231. Thanks and have a nice weekend also!

Good morning, thanks for your answer, it sounds that we have to dig in a bit deeper. I’ve informed the colleguages from your local support team in Spain, they will reach you out. Have a great day, best regards!

Good morning: Thank you very much!! Best regards!

Hi Bertha, Once you have a solution with the help of your local support team, can you please share it here for future reference?

Unable to find hardware configuration online

Ask Questions B&R Software & Runtime

c579738 (Bertha Lorenzo Ochoa) February 22, 2024, 2:34pm 15

Hello Lucas.

We did not find the solution.
we format the system and start again.

Thank you.

Topic		Replies	Views
Cpu x2p cp1484 does not connect online B&R Software & Runtime automation-studio	31	1456	April 2, 2024
Problem with the online connection to Power Panel 65 HMI & Visualization power-panel , automation-studio	16	546	July 15, 2024
Error 4808: No connection available to the PLC Controls & Vision automation-studio , plc	5	241	June 10, 2025
Can't identify hardware online x20cp1583 ( connecting using ethernet cable ) B&R Software & Runtime automation-studio	7	381	November 1, 2024
Unable to Ping or Go Online with B&R PLC 4PPC070.0573-20W Despite Being Visible in Browse B&R Software & Runtime t-c-panels	18	141	January 29, 2026

Unable to find hardware configuration online

Related topics